Here we have a wide selection of vehicle lights / work lights / driving lights / LED spot lights / flood lights / LED Light Bars and interior LED Lights. We have high luminosity LED lights and ultra bright Xenon HID lights, some are IP65 and some are IP67 compliant. Some have housings made of diecast aluminium and others are ABS plastic. Most have a wide voltage ranges.
We also have a range of NAS LED lights for Land Rover Defenders, clear sets and coloured sets. These Land Rover Defender NAS LED lights are for all post 1983 90 and 110, include front and rear NAS LED Lights with plinths, are waterproof to IP67, E marked (EU approved) and SAE approved, provide increased visibility (brighter than standard bulbs) and they enhance and modernise the look of your Defender, easy to fit DIY.
We also have a dedicated website for LED and HID Vehicle lights. See individual specifications for details. Call if you have any questions.
Aluminium Roof Light Bar For Defenders 90, 110 and 130.
- Lights not included!
- NOTE: If you have a snorkel already fitted, please check they will fit together. This roof light bar will fit along with a genuine land rover snorkel, or our Masai Snorkel. If you own any other after-market snorkel please check the fitments.
- Roof Light Bar suitable for Land Rover Defender 90 and 110.
- Aerodynamic swept Aluminium profile.
- Black powder coated matt finish.
- 4 adjustable position light mounting brackets.
- Easy to fit DIY, clamp-on system no drilling required.
- 150cm x 25cm x 15cm.
Fitting Tips
The design of this light bar enables 2 methods of fitting. There are two sets of holes in the light bar bracket. A set on the top (for use with method 1) and a set on the bottom (for use with method 2). The 2 sets of holes have not been designed to match with each other..
Method 1
The "clamp-on" systems uses a combination of a rubber block and securing bolts that secures the lightbar in place as the bolts are tightened. Due to the variance in gutter dimensions across different years and models, the rubber block may need to be cut with a Stanley Knife to fit.
Method 2
We recommend in cases where light bars are fitted with heavy lights, that a mechanical solution is applied to secure the light bar in place. This will require using the 2 holes on the bottom section of the light bar and drilling 2 holes into the gutter itself before securing with bolts (Not Supplied).
