We sell Land Rover Defender Snorkel Kits (also known as a Raised Air Intake). Snorkels protect engines from the damaging effects of water, dust and sand encountered in touring and off-roading.
Snorkel kit versions for Land Rover Defender 200TDI (left hand fitting kit) and 300TDI, TD5 and TDCI Puma (right hand fitting kit). Snorkel Kits are original Land Rover part number STC50265. For the 300TDI, TD5 and Puma we supply a right-hand bracket.
Roll-cage Snorkel – We also make a Defender Snorkel Kit version for Defenders with roll cages – the lower fitting is different to standard as it protrudes slightly more to accommodate for the position of the roll-cage tubing. The Masai Land Rover Defender Roll Cage Snorkel Kit is available for left hand side 200TDI and right hand 300TDI, TD5 and TDCI Puma.
Aluminium Roof Light Bar For Defenders 90, 110 and 130.
- Lights not included!
- NOTE: If you have a snorkel already fitted, please check they will fit together. This roof light bar will fit along with a genuine land rover snorkel, or our Masai Snorkel. If you own any other after-market snorkel please check the fitments.
- Roof Light Bar suitable for Land Rover Defender 90 and 110.
- Aerodynamic swept Aluminium profile.
- Black powder coated matt finish.
- 4 adjustable position light mounting brackets.
- Easy to fit DIY, clamp-on system no drilling required.
- 150cm x 25cm x 15cm.
Fitting Tips
The design of this light bar enables 2 methods of fitting. There are two sets of holes in the light bar bracket. A set on the top (for use with method 1) and a set on the bottom (for use with method 2). The 2 sets of holes have not been designed to match with each other..
Method 1
The "clamp-on" systems uses a combination of a rubber block and securing bolts that secures the lightbar in place as the bolts are tightened. Due to the variance in gutter dimensions across different years and models, the rubber block may need to be cut with a Stanley Knife to fit.
Method 2
We recommend in cases where light bars are fitted with heavy lights, that a mechanical solution is applied to secure the light bar in place. This will require using the 2 holes on the bottom section of the light bar and drilling 2 holes into the gutter itself before securing with bolts (Not Supplied).
