We design and manufacture high quality Side Steps and Rear Steps for the Land Rover Defender 90 and 110 – may fit other models too – just call. Folding Side Steps and Rear Steps mounted near towing point.
We also have the Land Rover Defender NAS Rear Step made of zinc plated galvanised steel, black powder coated complete with aluminium tread plate, holes for fitting a towing hook and accommodation for electrical sockets.
Our “Fire and Ice” style Defender Tubular Side Steps feature an attractive “Masai” branded tread plate made of rubber and brushed aluminium. It attaches with bolts and no drilling is required. Clamps to the chassis outriggers. All our steps are easy to fit DIY (instructions supplied).
For touring we designed a Wheel Step which fits most 4×4 wheels – it can be used as a viewing platform, seat or to assist in gaining access to your roof rack and engine. See video above.
XJ6 Jaguar Water Pump - Series II amd III
- This is a Jaguar Water Pump - Part No. EAC8053 / GWP427 (unipart number)
- Complete with Gasket (Part No. C28656)
- Incorporating the Multi-Vee Pulley (part No. EAC8051).
- Application: XJ6 Series II and III
This is the genuine Jaguar Original Equipment pump. This means that the pump components have been made to original Jaguar drawings and conform with all material and dimensional specifications. All castings are leak-tested prior to final assembly. The components are assembled to specification (exacting tolerances determined by Jaguar) e.g. pulleys are assembled to the correct height to minimise drive belt wear. Impellers are assembled to the correct height to ensure optimum performance and avoid a potentially disastrous foul condition. Bearings and seals are designed to withstand loads and forces prescribed by Jaguar as a result of exhaustive testing under extreme conditions. Assembly processes use load-monitoring to ensure components will not fail prematurely.
The life of a replacement OEM pump can, however, be adversely affected if the car's cooling system is not maintained. Before fitting a replacement pump, it is highly advisable to flush the cooling system under pressure, to clear accumulated debris within the system which can damage the pump if circulated. After the replacement pump has been fitted, the cooling system should be topped up to the correct level with the prescribed proportion of anti-freeze added. Anti-freeze is essential under all temperature conditions as it contains properties which lubricate the water pump seal. Not only does it prevent the coolant from freezing in extreme cold conditions, but it prevents the coolant from boiling in extreme heat.
